Application Instructions

Application Instructions

Thurmalox Weldable Weld Thru Primer

Conventional spray is the recommended method of application. This product may also be applied by airless spray, brush or roller. Do not apply in heavier films than specified since blistering may occur. Brush: Use only wooden-handled brush with short China bristles. Do not use synthetic-bristled brushes. Do not flood surface with coating. Brush out thoroughly, maintaining a continuous wet edge and uniform appearing paint film.

Roller

Use only wooden-handled roller with phenolic shank and core, and 1/4-3/8” nap. Do not flood surface with coating. Roll out excess coating on a suitable, screened surface. Then roll out thoroughly, maintaining a continuous wet edge and uniform appearing paint film.

Mixing

Redisperse any settled-out pigments by stirring with a paint paddle followed by thorough mixing to a uniform consistency with an explosion-proof or air-driven power mixer. Do not open containers until ready to use. Keep lid on container when not in use.

Cleanup

Thoroughly flush spray equipment and hoses immediately after use with Xylene Dismantle spray equipment and clean parts, brushes and rollers with Xylene.

Storage

Store in cool, dry place with temperature between 50°F and 100°F (10°C and 38°C). Keep container closed when not in use.

ALVIN PRODUCTS ~ A DIVISION OF DAMPNEY COMPANY, INC.
85 PARIS STREET ~ EVERETT, MA 02149
Phone (978) 423-7681 ~ Fax (617) 389-0484
COPYRIGHT© 2001 - 2012. ALL RIGHTS RESERVED.